Arduino tehNiq: May 2022

As a beginner with model railroading I tested also DCC control using a custom locomotive.

My custom locomotive was make using just bogie from an old locomotive, adding DCC ready board and NEM652decoder.

DCC control was choose as DCC++EX

so, I used for as Command Station: Arduino Mega development board, a Motor shield, ESP8266-01 with logical level adapter, i2c LCD1602 (and than OLED) display + 4 servos connected at an expander board on i2c with 16 outputs using PCA9685 chip, using info from

- https://dcc-ex.com/get-started/assembly.html

- https://dcc-ex.com/get-started/wifi-setup.html

- https://dcc-ex.com/get-started/installer.html

For the throttle I used 2 versions:

- DCC++Ex Web Throttle (https://dcc-ex.com/throttles/ex-webthrottle.html)

- Engine Driver Android app (https://dcc-ex.com/throttles/engine-driver.html)

I was interested to control servos (for future turnouts) so I used info from:

- https://dcc-ex.com/reference/software/hal-config.html

- https://dcc-ex.com/reference/software/command-reference.html

- https://dcc-ex.com/reference/software/command-summary.html

Base commands for turnouts in DCC++EX are:

and for SG90 servo:

Easiest mode is to use web throttle (serial control)

So, for first servo (turnout), command is <T 200 SERVO 100 410 205 3>, where 200 is choose ID for turnout, 100 is VPIN (virtual pin for first servo connected at PCA9685), 410 is PWM number for throw (open) for SG90, 205 is PWM number for close position and 3 is slowest movement (0 is fastest movement).

For second servo (turnout), command is <T 201 SERVO 101 410 205 3>, where 201 is choose ID for turnout, 101 is VPIN (virtual pin for second servo connected at PCA9685), 410 is PWM number for throw (open) for SG90, 205 is PWM number for close position and 3 is slowest movement..

So, for third servo (turnout), command is <T 202 SERVO 102 410 205 3>, where 202 is choose ID for turnout, 102 is VPIN (virtual pin for third servo connected at PCA9685), 410 is PWM number for throw (open) for SG90, 205 is PWM number for close position and 3 is slowest movement .

So, for first servo (turnout), command is <T 203 SERVO 103 410 205 2>, where 200 is choose ID for turnout, 100 is VPIN (virtual pin for first servo connected at PCA9685), 410 is PWM number for throw (open) for SG90, 205 is PWM number for close position and 2 is medium movement.